PIVOT 3 Drive Throttle Contoroller

PIVOT 3 Drive Throttle Contoroller

Brand: PIVOT
Product Code: PIVOT THF2
Availability: In Stock
$350.00 $298.00

Available Options

* Select:

Check here for Vehicle Fitting List  *Select for Vechile Model




3-drive · FLAT features

Ultra-thin Controller

Our 14mm FLAT model can be installed just about anywhere without interfering with the your interior design.


Mode Memory

The mode when you start the engine is selectable;
the "Same as last" mode or "Normal" mode.


3 Modes

Possible to change between three modes: SPORTS mode for higher acceleration response, ECO-mode for lower response and NORMAL mode for standard response.


12 steps

In the SPORTS mode, seven step ECO mode is a detailed adjustment of 12 all steps of five steps.


Acceleration Monitor

Open times of the accelerator (amount of depressing) are displayed and it is convenient for the eco-driving etc.


Easy Installation

Easy installation using car model specific coupling harness.


Initial Settings

Inisital settings can be made for each type of car making it compatible with a wide range of models.


Digital Circuitry

The high-speed circuitry signal output is not affected by temperature or noise and hence guards against troubles and failures.


Normal Control when in Reverse

When the vehicle is put into reverse it will automatically return to normal acceleration (wiring where necessary). However, usually when using reverse the degree of acceleration is at most about 10%; in this range there is hardly any change so it is not necessary to wire for using reverse.


Safety System

The acceleration mode will automatically be returned to "Normal" if the product should break or fail, or if the two signals should separate.


Basic Wiring

3-drive · FLAT Basic Wiring




3-drive · FLAT Content of control

3-drive · FLAT Acceleration output signal



3-drive · FLAT Size

1. This product is designed only for electronic throttle car models.
2. Before purchasing make sure to check the "Fitting List".
3. This product can not be installed in cars which use the different ECU from the standard or use a sub-computer.
4. Make sure to use the 3-drive harness.
5. Please carefully read the "User's manual" and carry out all operations with the utmost in safety.
6. Make sure to carry out "Initial Settings" before using the product.
7. Do not remodeling this product. It may cause damage not only to the product, but to the car and the operation of the car in which it is installed.


Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: